Updated November 2026
A single arm kettlebell row builds strength in your upper back, lats, rear shoulders and grip, one side at a time. Done with a flat back and a controlled pull, it is one of the most practical pulling moves you can do with a single weight. This guide covers setup, step-by-step form, a beginner-friendly routine and the mistakes that most often cause trouble.
What You Need Before You Start
You only need one kettlebell, a sturdy bench or chair, and a bit of floor space. Choose a weight that lets you complete 8 to 12 smooth reps with good form. Beginners often start lighter than they expect, especially if they are new to hinging at the hips.
Shopping for one? See our guide: 6 Best REP Fitness Adjustable Kettlebell Models for Home Workouts.
- One kettlebell, typically in the 10 to 25 pound range for beginners
- A stable bench, sofa edge or sturdy chair at about knee height
- A non-slip surface or mat
- A mirror or phone camera to check your back position
How to Perform the Single Arm Row Step by Step
Set Your Stance and Hinge
- Place your left knee and left hand on the bench, with your left hand directly under your shoulder.
- Keep your right foot planted on the floor, about hip-width behind you, with your knee bent comfortably.
- Hold the kettlebell in your right hand with your arm fully extended toward the floor and your palm facing your body.
- Keep your spine long and neutral. Your back should be flat, roughly parallel to the floor.
Pull and Lower With Control
- Brace your core, then pull the kettlebell toward your hip or lower ribs, keeping your elbow close to your body.
- Squeeze your shoulder blade back and down at the top for about one second.
- Lower the weight slowly over two to three seconds until your arm is fully extended again.
- Complete 8 to 12 reps, then switch sides.
Sample Beginner Routine
Start with two to three sets per side, resting about 60 seconds between sets. Add a set or a few reps each week as the movement feels stable. If you are also building pulling strength with bands, a seated row variation pairs well with this move on alternate days.
| Week | Sets per Side | Reps per Set |
|---|---|---|
| 1 to 2 | 2 | 8 to 10 |
| 3 to 4 | 3 | 10 to 12 |
| 5 and up | 3 to 4 | 10 to 12, heavier kettlebell |
Common Mistakes to Avoid
- Rotating the torso. Pulling with a twisting trunk shifts the load away from your back. Keep your shoulders square to the floor.
- Yanking the weight up. Pull with the back, not momentum. A slower pull is more effective and safer.
- Letting the shoulder shrug. Keep your shoulder down and away from your ear during the pull.
- Rounding the lower back. If your back bends, reduce the weight or raise your bench.
- Skipping the lowering phase. The controlled return builds strength as much as the pull does.
Recommended Gear
A non-slip mat helps your support hand and knee stay put during the set. A kettlebell with a comfortable handle makes it easier to keep a firm grip through the full range of motion. A stable adjustable bench gives you a consistent height for the setup.
- Exercise mats with a grippy surface keep your knee and hand from sliding: View on Amazon
- Kettlebells with a wide, smooth handle help your grip last through the set: View on Amazon
- Sturdy adjustable workout benches provide a steady, repeatable height: View on Amazon
Tips for Getting More From the Move
- Film one set from the side to check that your back stays flat.
- Pause for one second at the top of each rep to improve the squeeze.
- Progress by adding reps before adding weight.
- If you have a shoulder or back condition, check with a doctor or physical therapist before starting.
FAQ
Is the single arm kettlebell row good for beginners?
Yes, as long as you start with a light weight and focus on keeping your back flat. It is one of the more accessible pulling exercises for home training.
How often should I do single arm rows?
Two to three times per week with at least one rest day between sessions is a common starting point for most people.
Can I do this without a kettlebell?
You can substitute a dumbbell, a filled backpack or a heavy water jug. The form stays the same, though a kettlebell’s handle position can feel different.
Conclusion
The single arm kettlebell row is a simple way to build a stronger back, better grip and more balanced pulling strength. Start light, keep your torso steady and lower the weight with control. Progress slowly, and talk with a qualified professional if you have an existing injury.

