Updated November 2026

A single arm kettlebell row builds strength in your upper back, lats, rear shoulders and grip, one side at a time. Done with a flat back and a controlled pull, it is one of the most practical pulling moves you can do with a single weight. This guide covers setup, step-by-step form, a beginner-friendly routine and the mistakes that most often cause trouble.

What You Need Before You Start

You only need one kettlebell, a sturdy bench or chair, and a bit of floor space. Choose a weight that lets you complete 8 to 12 smooth reps with good form. Beginners often start lighter than they expect, especially if they are new to hinging at the hips.

Shopping for one? See our guide: 6 Best REP Fitness Adjustable Kettlebell Models for Home Workouts.

  • One kettlebell, typically in the 10 to 25 pound range for beginners
  • A stable bench, sofa edge or sturdy chair at about knee height
  • A non-slip surface or mat
  • A mirror or phone camera to check your back position

How to Perform the Single Arm Row Step by Step

Set Your Stance and Hinge

  1. Place your left knee and left hand on the bench, with your left hand directly under your shoulder.
  2. Keep your right foot planted on the floor, about hip-width behind you, with your knee bent comfortably.
  3. Hold the kettlebell in your right hand with your arm fully extended toward the floor and your palm facing your body.
  4. Keep your spine long and neutral. Your back should be flat, roughly parallel to the floor.

Pull and Lower With Control

  1. Brace your core, then pull the kettlebell toward your hip or lower ribs, keeping your elbow close to your body.
  2. Squeeze your shoulder blade back and down at the top for about one second.
  3. Lower the weight slowly over two to three seconds until your arm is fully extended again.
  4. Complete 8 to 12 reps, then switch sides.

Sample Beginner Routine

Start with two to three sets per side, resting about 60 seconds between sets. Add a set or a few reps each week as the movement feels stable. If you are also building pulling strength with bands, a seated row variation pairs well with this move on alternate days.

Week Sets per Side Reps per Set
1 to 2 2 8 to 10
3 to 4 3 10 to 12
5 and up 3 to 4 10 to 12, heavier kettlebell

Common Mistakes to Avoid

  • Rotating the torso. Pulling with a twisting trunk shifts the load away from your back. Keep your shoulders square to the floor.
  • Yanking the weight up. Pull with the back, not momentum. A slower pull is more effective and safer.
  • Letting the shoulder shrug. Keep your shoulder down and away from your ear during the pull.
  • Rounding the lower back. If your back bends, reduce the weight or raise your bench.
  • Skipping the lowering phase. The controlled return builds strength as much as the pull does.

A non-slip mat helps your support hand and knee stay put during the set. A kettlebell with a comfortable handle makes it easier to keep a firm grip through the full range of motion. A stable adjustable bench gives you a consistent height for the setup.

  • Exercise mats with a grippy surface keep your knee and hand from sliding: View on Amazon
  • Kettlebells with a wide, smooth handle help your grip last through the set: View on Amazon
  • Sturdy adjustable workout benches provide a steady, repeatable height: View on Amazon

Tips for Getting More From the Move

  • Film one set from the side to check that your back stays flat.
  • Pause for one second at the top of each rep to improve the squeeze.
  • Progress by adding reps before adding weight.
  • If you have a shoulder or back condition, check with a doctor or physical therapist before starting.

FAQ

Is the single arm kettlebell row good for beginners?

Yes, as long as you start with a light weight and focus on keeping your back flat. It is one of the more accessible pulling exercises for home training.

How often should I do single arm rows?

Two to three times per week with at least one rest day between sessions is a common starting point for most people.

Can I do this without a kettlebell?

You can substitute a dumbbell, a filled backpack or a heavy water jug. The form stays the same, though a kettlebell’s handle position can feel different.

Conclusion

The single arm kettlebell row is a simple way to build a stronger back, better grip and more balanced pulling strength. Start light, keep your torso steady and lower the weight with control. Progress slowly, and talk with a qualified professional if you have an existing injury.

Claire Whitaker

About Claire Whitaker

Claire Whitaker is part of our editorial team and reviews and edits our small & portable fitness equipment + low-impact training guides, checking product details against manufacturer specifications and owner feedback.